Evacuation light DP-LED 3W Li-FePO4 battery 3h IP20 Recessed with self-test

Installation of this product must be done in conjunction with this information sheet and should be performed

qualified electrician. Before installation, make sure that the power supply is isolated.

SPECIFICATION:

Nominal voltage: 220-240V - 50/60Hz

Input power: 0.8W

Lumens: 152 lm

Battery: Li-FePo4 3.2V 3000mAh

Lamp: 3W LED

Emergency duration: 180 minutes

Charging time: about 24 hours

Temperature range: 0°C - 40°C

INSTALLATION INSTRUCTIONS

1. Connect the power cord to the device using the supplied plug and socket.

To fully charge the battery, the device must have constant power. Connect the switch if the device has to

run in maintenance mode.

2. Connect the LED lamp and battery to the LED module.

3. Insert the module and battery through the 60mm diameter installation hole in the ceiling and

distribute the weight evenly on the ceiling. Secure the LED light in place using two

spring clip.

4. Turn on the mains and check if the green LED is on (be

be careful not to look directly into the LED light as it may damage your eyes).

AUTO TEST MANUAL

(AC 220-240V POWER SUPPLY)

INDICATOR PERFORMANCE:

Working device: Green indicator is working.

Battery failure: Red indicator flashes (flashes once every 3 seconds.)

Light source failure: red indicator flashes (flashes twice every 3 seconds)

Shorter duration than specified: red indicator flashes quickly (flashes three times every 3 seconds)

AUTOMATIC TEST

After installing the security light:

1. An automatic test is carried out once a month, which lasts 10 minutes. The lighting will return to normal operation after 10 minutes.

2. An automatic test is conducted once a year, which lasts 3 hours. The lighting will return to normal operation after 3 hours.

3. When the automatic test starts, the light turns on. It also interrupts the battery charge, which stops the green indicator from working.

The red indicator flashes continuously.

4. If the emergency duration is shorter than the set time, the red light will flash.